FAQs TRONIC EVOLUTION 2013_english

FREQUENTLY ASKED QUESTIONS
FAQ's
207004
T.
ABSA.SA
www.keya.es
Electronic lock
Once assembled, the lock does not work when the keybuttons are pressed (no sound and the lock does not work)
1 Verify that the cable is properly connected (straight and until the bottom).
2 Verify that the batteries are in the right polarity (indicated inside).
1/4
FREQUENTLY ASKED QUESTIONS
FAQ's
207004
T.
ABSA.SA
www.keya.es
The latch does not open/close after a correct code
1 Verify that the screws are not too much fastened (<20kgfcm).
2 Verificar que el pestillo entra y sale sin impedimento (roce/interferencia contra el marco).
2/4
FREQUENTLY ASKED QUESTIONS
FAQ's
207004
T.
ABSA.SA
www.keya.es
After introducing a correct code and pressing ENTER, the three leds blinks at the same time (green – yellow –
red) and the lock does not work.
1
Dead bateries: they should be replaced for a new ones.
After pressing any button blinks the yellow led.
1 Dead bateries or almost dead: they should be replaced for a new ones.
3/4
FREQUENTLY ASKED QUESTIONS
FAQ's
207004
T.
ABSA.SA
www.keya.es
The batteries are dead with the door close (I can not access to the battery pack to replace them).
1 Connect the BATPACK to the lock through the mini-USB connector, as the picture below shows.
2 With the BATPACK connected (in ON position) introduce the user code (or the master one) and then open
the lock.
3 Disconnect the BATPACK and replace the old batteries for new ones.