emacold 80" brillo

EMACOLD 80" BRILLO
IMAGE PRODUCTS APPLICATION GUIDE
Non-UV cold laminating film provides glossy, semi-matte (#002) & matte (#005) for use on all laminating machines for further protection on each valuable output print. When using
Emaser non UV laminating film, images can be archived for longer period of life time and different viewing effects by variety of laminating film finishes. For over 48" high hanging
posters, 0.15mm thick laminating film is recommended to enhance the poster strength.
MEDIA ATTRIBUTES
Glossy
Available Width:
37", 43", 51", 55", 61"
Semi-matte (#002-low glare)
Adhesive:
Yes, mid tack.
Matte (#005 non glare)
Option:
1. 0.15mm thick material
Material:
Monomeric Calendared Polyvinyl Chloride,
2. Double sides PE coated kraft
Cadmium free.
Life expectancy:
3 months in outdoor exposure condition,
Basis Caliper:
3 mil (0.08mm)
up to 3 years in indoor condition.
Basis Weight:
105 g/㎡ (excludes adhesive & backliner weight)
APPLICATION GUIDELINES
Laminating Operation:
The film side is wound to the outside of the roll.
FINISHING RECOMMENDATIONS
These
products
can
be
operated
with most cold laminators and hot laminators with temperature heater being switched off. Overlap the
Lamination:
image with a 0.25" safe edge of laminate. This will seal the photobase paper, preventing moisture absorption and paper splitting. Use
laminates of equal gauge when encapsulating to prevent image curl. Overlaminating will decrease the rate at which the images fade.
Gloss Level:
Adhesive type:
Back liner:
Permanent, mid tack, solvent based.
80 gsm kraft with PE coated on single side.
BACK ADHESIVE ATTRIBUTES
Quick tack:
Peel 20 min:
Peel 24 h:
10~13 N / 25mm
8~10 N / 25mm
14~16 N / 25mm