Preparing the Filter and Bucket Instructions-SP180 Paso 1
Transcripción
Preparing the Filter and Bucket Instructions-SP180 Paso 1
Sawyer PointONEFilter™ Instructions for the SP180 - Page 1 Preparing the Filter and Bucket Instructions-SP180 Filtro punto UNO Instrucciones. Lean todas las instrucciones antes de comenzar. Paso 1- Verifique el contenido de ensamble del juego (A) – 1 Filtro adaptador y manguera (B) – 1 Cortador de hueco (C) – 1 Jeringa (D) – 1 Gancho del filtro Paso 2- Busque un tarro o cubo “limpio” Paso 3- Hacer un hueco en el tarro Un talador no es requerido. Se puede hacer a mano. Esta altura previene que el sedimento entre en el filtro. • Comience empujando duro el cortador de hueco. Sawyer PointONEFilter™ Instructions for the SP180 - Page 2 • • Taladre un 22 mm (13/16”) hueco en el lado del tarro aproximadamente 38 mm (1.5”) del fondo torciendo el cortador de hueco (B). Despues de taladrar el hueco, asegurese de que alrededor del hueco este liso. No teniendo un hueco limpio puede causar un goteo. Paso 4- Prepare el adaptador Destornille el adaptador masculino del adaptador femenino. Sawyer PointONEFilter™ Instructions for the SP180 - Page 3 Remueva el anillo del adaptador masculino. Paso 5- Instalar el adaptador masculino Ponga el adaptador masculino a través del hueco dentro del tarro. Las roscas serán visibles afuera del tarro. Sawyer PointONEFilter™ Instructions for the SP180 - Page 4 Paso 6- Instalar el anillo Ponga el anillo sobre las roscas masculino afuera del tarro. Paso 7- Ponga junto el adaptador femenino sobre las roscas del adaptador masculino y atornille el adaptador femenino atrás sobre las roscas masculinas. Sawyer PointONEFilter™ Instructions for the SP180 - Page 5 Paso 8- Filtrando el agua IMPORTANTANTE – SIEMPRE FILTRE EL AGUA EN UN TARRO LIMPIO. • • Primero cuelgue el filtro al borde del tarro adquirido como se ve. Agregue agua al tarro. Si el agua es muy sucia, cuélelo atreves de un paño como se ve. • • Ponga el tarro o el envase abajo del tarro adquirido. Baje el filtro abajo del fondo del tarro para comenzar el fluido. Entre mas es la distancia entre el filtro y la parte de la línea del agua, mas rápido el agua fluirá. Sawyer PointONEFilter™ Instructions for the SP180 - Page 6 Paso 9- Pare el fluido del agua Suba el filtro arriba del tarro para parar el fluido del agua. Cuando no se use, ponga el filtro dentro del gancho del filtro y cuélguelo a un lado del tarro.