In ita lla ts no I sn rtuc it nos ofr D E L Lin ra e T bue

In ita lla ts no I sn rtuc it nos ofr D E L Lin ra e T bue

Installation Instructions for LED Linear Tube
1. Remove the Fluorescent tubes and Ballast.
2. Install the LED External Driver into the cavity of the fixture replacing the
Fluorescent Ballast. Wire the Live wire and Neutral Wire to the LED Driver.
3. Install the LED Linear Tube into the fixture, using the existing holders for the
tube. Connect the LED Linear tube to the LED Driver by connecting the (+) and
(-) wires. The connector will clip together and hold together.
4. The complete LED Linear Tube installation will look as follows;
1. The LED Driver is connected directly to the incoming Live and Neutral
2. The LED Driver is connected to the LED Tube by the connector
3. The LED Tube is secured into the fixture using the present holders
5. Please Note:
1. There is no electricity passing into the existing holders of the LED Linear
Tube.
2. You will require 1 LED Driver for every LED Linear Tube.
3. (1) LED Drivers is included with each tube when purchased.